paintballHomepaintballPicturespaintballTechnicalpaintballTournamentpaintballRecreationalpaintballFieldspaintballStorespaintball
paintballBeginner InfopaintballNews And ArticlespaintballLinkspaintballResourcespaintballVideopaintballContact UspaintballSearchpaintball
WARPIG Tank Talk

another factor

In Reply to: Valve Selection posted by Dave Hall on May 06, 2003 at 16:46:12:


[ Follow Ups ] [ Post Followup ] [ WARPIG Tank Talk ]

Posted by:
Michael "LCT_Paintball" Lyon
on May 06, 2003 at 17:26:35

Another factor that is not as obvious is the through put of the valve. I have seen some 1" valves that are very restrictive in the valve area. So much that I've wondered if they don't use the same diaphram and internal portion of the mold on the 1" and the 3/4". IOW, maybe all they do is change the part of the mold that creates the female threads, but don't increase the volume of water that can flow through the valve it's self.

Follow Ups:


Post a Followup

Show your name as:

E-Mail address (eg: joeschmoe@aol.com):


Show your e-mail address?

Your Password:


Don't have a password? CLICK HERE - Forgot your password? CLICK HERE

Subject:

Subject:Message:


[ Follow Ups ] [ Post Followup ] [ WARPIG Tank Talk ]


Copyright © 1992-2019 Corinthian Media Services.

WARPIG's webmasters can be reached through our feedback form.  All articles and images are copyrighted and may not be redistributed without the written permission of their original creators and Corinthian Media Services. The WARPIG paintball page is a collection of information and pointers to sources from around the internet and other locations. As such, Corinthian Media Services makes no claims to the trustworthiness or reliability of said information. The information contained in, and referenced by WARPIG, should not be used as a substitute for safety information from trained professionals in the paintball industry.