|
|
|
Posted by Daniel "Killer_Meat" DeMerchant on March 29, 2002 at 23:31:03:
In Reply to: Blowback noise reduction (long) posted by
>: Daniel DeMerchant posted recently one of the >major causes of noise in the M98, the sudden >release of blowback gas as the O-ring on the >hammer reaches the side slot. This is not what I said. The major cause of Dan.
the pop is when the O-ring passes the end of
the power tube, not when the hammer reaches
the side slot. The air goes around the hammer
when the O-ring passes the end of the power tube.