Posted by: hipboyscott on July 31, 2003 at 18:57:20

I've seen it done before, If you describe what I picture. It's basically making the bolt no longer than the connecting pin that links the bolt to the hammer, and removing all of the upper tube as posible. I think I even saw a Brass Eagle with this setup!! even the venerable 'cocker has been hacked in such a way; the bolt rides above the hammer, with pins coming from the bottom of the bolt to pull the hamemr back. thus the back block's right behind the feed tube. I think that I have a working design that reduces the profile even more by using the valve AS the bolt! that's my new tech, but I need machining tools to make it with :(

Follow Ups: Post a Followup Show your name as: DefaultRealnameBothNickname E-Mail address (eg: joeschmoe@aol.com): Show your e-mail address? DefaultYesNo Your Password: Don't have a password? CLICK HERE - Forgot your password? CLICK HERE Subject: Subject:Message: : I've seen it done before, If you describe what I picture. : It's basically making the bolt no longer than the connecting pin that links the bolt to the hammer, and removing all of the upper tube as posible. I think I even saw a Brass Eagle with this setup!! : even the venerable 'cocker has been hacked in such a way; the bolt rides above the hammer, with pins coming from the bottom of the bolt to pull the hamemr back. thus the back block's right behind the feed tube. I think that I have a working design that reduces the profile even more by using the valve AS the bolt! that's my new tech, but I need machining tools to make it with :( [ Follow Ups ] [ Post Followup ] [ WARPIG Tech Talk - Spyder ]