|
|
|
|
|
|
|
Posted by WARPIG Tech on April 22, 2002 at 20:44:25:
In Reply to: How much should I feed an IR3? posted by
: I ordered a new IR3 coming in this week and was wondering how much pressure I need to feed this thing. WDPs site doesnt tell me. I have a retro mag that I'm feeding 700psi and wanted to take the tank off there and put it on the IR3. It would be nice if I could leave the pressure the same so I could swap back and forth quickly if I had to without re-adjusting the output pressure. A lot of folks run 600-650 psi, but 700 will work fine, as I know a number of folks who have run Angels off of preset regs, meaning they can handle 800. See you on the field,
-Bill Mills