paintballHomepaintballPicturespaintballTechnicalpaintballTournamentpaintballRecreationalpaintballFieldspaintballStorespaintball
paintballBeginner InfopaintballNews And ArticlespaintballLinkspaintballResourcespaintballVideopaintballContact UspaintballSearchpaintball
WARPIG Tech Talk - Angel / Angel LCD
Re: intelifeed wire
[ Follow Ups ] [ Post Followup ] [ WARPIG Tech Talk - Angel / Angel LCD ]

Posted by fiberoptix227 on May 03, 2002 at 09:16:25:

In Reply to: intelifeed wire posted by Sneakyman on May 01, 2002 at 18:05:41:

:
if you are using a standard 12 volt rev you take all the wires and sensors out. Then take the rev motor out take the bottom of it off and unhook the wires there and solder the intelifeed wires on it and run the wire to the gun and you are ready to go



Follow Ups:


Post a Followup

Show your name as:

E-Mail address (eg: joeschmoe@aol.com):


Show your e-mail address?

Your Password:


Don't have a password? CLICK HERE - Forgot your password? CLICK HERE

Subject:

Subject:Message:

[ Follow Ups ] [ Post Followup ] [ WARPIG Tech Talk - Angel / Angel LCD ]

Copyright © 1992-2019 Corinthian Media Services.

WARPIG's webmasters can be reached through our feedback form.  All articles and images are copyrighted and may not be redistributed without the written permission of their original creators and Corinthian Media Services. The WARPIG paintball page is a collection of information and pointers to sources from around the internet and other locations. As such, Corinthian Media Services makes no claims to the trustworthiness or reliability of said information. The information contained in, and referenced by WARPIG, should not be used as a substitute for safety information from trained professionals in the paintball industry.