|
|
|
Re: Hammer and Valve Springs
In Reply to: Hammer and Valve Springs posted by Devon on March 08, 2003 at 00:36:26:
|
Posted by: Sinagent on March 13, 2003 at 23:45:02
|
1st off, LP is not less efficent than HP. IT is more efficent if properly set up. got to http://www.moodypaintball.com/pages/tech/reg.htm that will show you how to set your reg to the most efficent pressure and how to get the right spring combo. HP uses a high pressure wiht less volume to shot the paintball, while LP uses a lower pressure and a higher volume, but the volume, if set up as shown on moody paintball, is controlled, so you are using only as much as is need to shot the ball. also, low pressure is softer on the ball, and your springs can be much lighter, so you can turn your LPR down so low you will vutually never break another ball if you out shot your hopper or short-stroke. hope that helps. |
Follow Ups:
|
Copyright © 1992-2019
Corinthian Media Services. WARPIG's webmasters can be reached through our feedback form. All articles and images are copyrighted and may not be redistributed without the written permission of their original creators and Corinthian Media Services. The WARPIG paintball page is a collection of information and pointers to sources from around the internet and other locations. As such, Corinthian Media Services makes no claims to the trustworthiness or reliability of said information. The information contained in, and referenced by WARPIG, should not be used as a substitute for safety information from trained professionals in the paintball industry. |