|
|
|
Re: Sticky Trigger and Chopping balls
In Reply to: Sticky Trigger and Chopping balls posted by DLS_Ace on May 03, 2003 at 21:58:03:
|
Posted by: Dale "Head_Hunters" DuPont on May 04, 2003 at 10:24:04
|
Trigger return spring may be too light? 3 way connecting rod binding in trigger? If your front reg is set too high, it can cause sticking sometimes. I think the excess pressure tries to force the O ring down the bore and it binds up the 3 way. Union between 3 way and 3 way connecting rod misaligned causing binding at the trigger and or 3 way. Some folks use Teflon Tape or Loctite to install the 3 way into the front block to take of the "looseness". The "looseness" is there on purpose so the 3 way can 'float' and self align with the 3 way rod and not bind. If if you have done this, undo it. |
Follow Ups:
|
Copyright © 1992-2019
Corinthian Media Services. WARPIG's webmasters can be reached through our feedback form. All articles and images are copyrighted and may not be redistributed without the written permission of their original creators and Corinthian Media Services. The WARPIG paintball page is a collection of information and pointers to sources from around the internet and other locations. As such, Corinthian Media Services makes no claims to the trustworthiness or reliability of said information. The information contained in, and referenced by WARPIG, should not be used as a substitute for safety information from trained professionals in the paintball industry. |