Posted by: pntballfreak on May 06, 2003 at 16:01:27

I think you might need something hotter than a lighter. Small torch will do the job...maybe a butane lighter??? You can try soaking the area with WD-40 overnight. You'll be able to loosen whatever was red loctited(sp? is that even a word? hehe). : Thanks! I'll be good from there. So the only way to remove locktite is to apply heat...say from a lighter? Or can I go about removing the residue using some other removal method? So far I've been picking at it with a compass use for drawing lol. Sounds cheap but it works. I don't have any fine tools quite yet....so I had to make due. Any further info would be appeciated. Thx again.

Follow Ups: Info... Vampyr 21:46:29 05/07/03 (0) Re: A propane/butane torch Dale "Head_Hunters" DuPont 13:05:44 05/07/03 (0) Post a Followup Show your name as: DefaultRealnameBothNickname E-Mail address (eg: joeschmoe@aol.com): Show your e-mail address? DefaultYesNo Your Password: Don't have a password? CLICK HERE - Forgot your password? CLICK HERE Subject: Subject:Message: : I think you might need something hotter than a lighter. Small torch will do the job...maybe a butane lighter??? You can try soaking the area with WD-40 overnight. You'll be able to loosen whatever was red loctited(sp? is that even a word? hehe). : : Thanks! I'll be good from there. So the only way to remove locktite is to apply heat...say from a lighter? Or can I go about removing the residue using some other removal method? So far I've been picking at it with a compass use for drawing lol. Sounds cheap but it works. I don't have any fine tools quite yet....so I had to make due. Any further info would be appeciated. Thx again. [ Follow Ups ] [ Post Followup ] [ WARPIG Tech Talk - Autococker / Minicocker ]