Posted by: aceiii1 on December 29, 2002 at 14:55:23

: : Apparently i accidentally tightened the cocking rod on my autococker too much. Now, when i try to remove it, the endpiece just unscrews. I've tried using a wrench on the rod itself, tightening the set screw more, and even locktight but it just keeps coming apart. Any suggestions? I did this when did that. Remove bolt then remove the back block conting the number of turns and remove the beaver tial if you have one. then just take a pair of vice gripes get then goo dand thight on the cocking rod and start trying to unsrew it much simper than taking the gun arart

Follow Ups: Post a Followup Show your name as: DefaultRealnameBothNickname E-Mail address (eg: joeschmoe@aol.com): Show your e-mail address? DefaultYesNo Your Password: Don't have a password? CLICK HERE - Forgot your password? CLICK HERE Subject: Subject:Message: : : : : Apparently i accidentally tightened the cocking rod on my autococker too much. Now, when i try to remove it, the endpiece just unscrews. I've tried using a wrench on the rod itself, tightening the set screw more, and even locktight but it just keeps coming apart. Any suggestions? : I did this when did that. Remove bolt then remove the back block conting the number of turns and remove the beaver tial if you have one. then just take a pair of vice gripes get then goo dand thight on the cocking rod and start trying to unsrew it much simper than taking the gun arart [ Follow Ups ] [ Post Followup ] [ WARPIG Tech Talk - High End Paintguns ]